Chapter 4 Hardware Settings - TMC TI5VGA User Manual

Chapter 4 Hardware Settings

The following sections describe the necessary procedures and proper
jumper settings to configure the TI5VGA motherboard.
4.1 SW1(1-8): CPU Frequency Selector ......................................... 15
4.2 JP1: DRAM Operating Frequency ............................................ 18
4.3 JP3, SW2(1-4): CPU Vcore Voltage Selector........................... 18
4.4 JP5: Clear CMOS Selection ...................................................... 20
The TI5VGA-100MHz, on the other hand, supports VIA's MVP3
chipset and has a maximum CPU bus speed of 100MHz. Please note the
correct settings of both the CPU and SDRAM clocks.
In the case your motherboard TI5VGA-100MHz has a processor
supporting 100MHz CPU clock (such as AMD K6-2/300) and your
DIMM module is PC100 compliant, the SDRAM clock can be set to
100MHz. Otherwise, set the SDRAM clock at 66MHz.
For the locations of the jumpers, refer to Figure 2 on the following page.
The following examples show the conventions used in this chapter
TI5VGA Socket 7 MVP3 ATX Motherboard User's Manual
Chapter 4 Hardware Settings
Jumper Open
Jumper Closed
Switch 1 and switch 2 are set to OFF.
Switch 3 and switch 4 are set to ON.
13