NordicTrack T9si User Manual page 9

8. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Identify the Right Handrail (105), which is
marked with a sticker. Hold the Right Handrail
near the console assembly.
Next, insert the console wire through the indi-
cated holes in the Right Handrail (105) as
shown.
9. Attach the Left Handrail (101) and the Right
Handrail (105) to the console assembly with four
#8 x 1/2" Screws (2), two 3/8" x 3/4" Patch Bolts
(8), and two 3/8" Star Washers (10). Do not
fully tighten the Screws or Patch Bolts yet.
10. Press the Left Handrail Cover (100) against the
console assembly. See the inset drawing.
Align the lip on the Left Handrail Cover with the
lip on the console assembly. Then, fully tighten
the four #8 x 1/2" Screws (2) in the Left Handrail
(101). Note: The Screws are preattached.
Repeat this step with the Right Handrail
Cover (107).
Tighten two 1/4" x 1/2" Bolts (3) into the
Handrails (101, 105) and the console assembly.
See step 9. Fully tighten the four #8 x 1/2"
Screws (2) and the two 3/8" x 3/4" Patch Bolts
(8).
8
Console
Assembly
9
8
101
10
2
10
100
3
2
2
101
Lips
9
Console Wire
Holes
105
8
105
10
Console
Assembly
2
3
2
107
Console
Assembly
2
105