NordicTrack T9si User Manual page 7

2. With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (57) so that the treadmill is more stable;
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Cut the shipping ties securing the Upright Wire
(97) to the Base (95). Locate a tie in the indi-
cated hole in the Base, and use the tie to pull
the Upright Wire out of the hole.
Attach a Base Foot (93) to the Base (95) in the
location shown with a #8 x 1" Tek Screw (4) and
a Base Foot Spacer (11). Then, attach another
Base Foot (93) with only a #8 x 1" Tek Screw (4).
3. Attach a Wheel (96) with the 3/8" Nut (9) and
the 3/8" x 2" Bolt (5) that you removed in step 1.
Do not overtighten the Nut; the Wheel must
turn freely.
4. Identify the Right Upright (86) and the Right
Upright Spacer (92), which are marked with
"Right" stickers. Insert the Upright Wire (97)
through the Right Upright Spacer as shown. Set
the Right Upright Spacer on the Base (95).
Have a second person hold the Right Upright
(86) near the Base (95). See the inset drawing.
Tie the wire tie in the Right Upright securely
around the end of the Upright Wire (97). Then,
pull the other end of the wire tie until the Upright
Wire is routed completely through the Right
Upright.
2
95
11
93
57
3
95
5
96
9
4
97
Wire Tie
86
97
Wire
Tie
7
B
97
4
86
A
Hole
93
4
97
92
95