Teeter Hang Ups Inversion Bar User Instructions

Figure 1
plastic
rotating
lock
u-shaped
receiver
Figure 2
DO NOT USE THE Inversion Bar IN DOORWAYS WIDER THAN 36" (91 cm).
•
Your Inversion Bar is pre-assembled in two halves which slide together to fit in doorways
from 28 to 36 inches (71 cm to 91 cm) wide.
•
USE ONLY in solid wood doorways built according to national building codes. Do not use
in faux or metal doorways.

Installation of Brackets:

• Important: There are two sizes of Locking Brackets, one to fit the large
diameter tube (with blue hand grips) and one to fit the small diameter tube (with
red warning label). The Locking Brackets should mount on the door frame
opposite from the hinged door, to allow use of the equipment without interfer-
ing with operation of the door.
• Install the first bracket as shown in Figure 1. Place the Locking Bracket
against the doorstop edge, and 2" (5 cm) or more down from the top of the
door frame. CAUTION: Make sure the plastic rotating lock is on top.
• Mark and then drill three 5/32" (3.9 mm) diameter holes and drill at least 2"
(5cm) deep into the door frame.
• Mount the Locking Bracket using the three wood screws provided. YOU
MUST USE THE SCREWS PROVIDED—DO NOT SUBSTITUTE WITH
OTHER LENGTH SCREWS. Screws must fully engage the door frame. (To
make the installation easier, rub bar soap on the screw threads.)
• Install the second Locking Bracket on the opposite side of the door frame at
the same height as the first Locking Bracket. After both Locking Brackets are
installed, extend your Inversion Bar out to the width of the door frame and
hook the flared tube ends into the u-shaped receiver in each Locking Bracket.
• Lock the Inversion Bar into the Locking Brackets by snapping the plastic
rotating lock over the top of the bar. See Figure 2. IMPORTANT: Always
check to make sure the tubes are securely locked in place before hanging on
the bar. Failure to do so could cause serious injury or death!
After installing the Locking Brackets and securing the Inversion Bar in place,
While hanging, bounce up and down several times. Next, both people should hang
IF THE DOOR FRAME IS UNSTABLE OR WEAK, DO NOT CONTINUE
CAUTION: ONLY ONE PERSON AT A TIME SHOULD USE THE INVERSION BAR FOR
Teeter Hang Ups
Boots, which have been designed specifically for use with the Inversion Bar.

Assembly Instructions

CAUTION!
FAILURE TO PROPERLY INSTALL THE INVERSION BAR
COULD RESULT IN SERIOUS INJURY OR DEATH.
TO TEST BAR INSTALLATION:
two people should hang by their hands from one end of the bar.
from the other end of the bar and repeat the test.
USE OF THE BAR IN THAT DOOR FRAME.
INVERSION. DO NOT ALLOW CHILDREN TO USE UNSUPERVISED.
Inversion Bar to be used only with SL Spyder
®
WARNING!
ATTENTION!
TM
Gravity