Derbi boulevard 125 4t Workshop Manual page 76

Electrical system
Sealed battery
If the vehicle is provided with a sealed battery, the only maintenance required is the check of its charge
and recharging, if necessary.
These operations should be carried out before delivering the vehicle, and on a six-month basis while
the vehicle is stored in open circuit.
Besides, upon pre-delivery it is therefore necessary to check the battery charge and recharge it, if
required, before storing the vehicle and, afterwards, every six months.
INSTRUCTIONS FOR THE RENEWAL RECHARGE AFTER OPEN-CIRCUIT STORAGE
1) Voltage check up
Before installing the battery on the vehicle, check the open circuit voltage with a regular tester.
- If voltage exceeds 12.60 V, the battery can be installed without any renewal recharge.
- If voltage is below 12.60 V, a renewal recharge is required as explained in 2).
2) Constant voltage battery charge mode
- Constant voltage charge equal to 14.40 ÷ 14.70V
-Initial charge voltage equal to 0.3 ÷ 0.5 for Nominal capacity
- Charge time:
10 to 12 h recommended
Minimum 6 h
Maximum 24 h
3) Constant current battery charge mode
- Charge current equal to 1/10 of the battery rated capacity
- Charge time: Maximum 5 h
Dry-charge battery
WARNING
- Battery electrolyte is toxic and it may cause serious burns. It contains sulphuric acid. Avoid contact
with eyes, skin and clothing. In case of contact with eyes or skin, flush abundantly with water for about
15 minutes and seek immediate medical attention.
In the event of accidental ingestion of the fluid, immediately drink large quantities of water or milk. Follow
with milk of magnesia, beaten egg or vegetable oil. Seek immediate medical attention
Batteries produce explosive gases; keep clear of free flames, sparks or cigarettes; ventilate the area
when recharging the battery indoors.
Always protect your eyes when working close to batteries.
Keep out of the reach of children.
ELE SYS - 76