Derbi boulevard 125 4t Workshop Manual page 67

Electrical system
Immobiliser
The electric ignition system is fed with direct cur-
rent and is protected by an anti-theft immobilizer
integrated to the control unit.
The ignition system consists of:
- electronic control unit
- immobilizer aerial
- master and service keys with built-in transponder
- HV coil
- diagnosis LED
The diagnosis LED also works as a blinking light
to deter theft. This function is activated every time
the key switch is turned to «OFF», and it remains
active 48 hours so as not to affect the battery
charge.
When the ignition switch is set to «ON», the theft
deterring blinker function is deactivated. Subse-
quently, a flash confirms the switching to «ON».
The duration of the flash depends on the electronic
control unit program (see figure).
Whenever the LED is off and remains so, even
when switching it to «ON», it is necessary to check
if:
- the battery is charged
- 15A main fuse is working correctly.
Connect the immobilizer tester to the diagnosis
socket (see ET4 125 manual) located behind the
front left fuse box flap.
If the serial LED remains off, check the electronic
control unit supply as follows:
ELE SYS - 67