Derbi boulevard 125 4t Workshop Manual page 121

Engine
- Fit the automatic valve-lifter retaining dish, using
the counterweight screw fastener as a reference.
- Tighten the clamping screw to the prescribed tor-
que.
Locking torques (N*m)
Locking torque 12 - 14
- Set the tensioner cursor in the rest position.
- Fit the chain tensioner on the cylinder, using a new gasket, and tight the two screws to the prescribed
torque.
Locking torques (N*m)
Locking torque 11 ÷ 13
- Insert the chain tensioning screw, together with the spring and washer, tightening it to the prescribed
torque.
Locking torques (N*m)
Locking torque 5 - 6
- Adjust the valve clearance.
- Fit the spark plug
Electric characteristic
Recommended spark plug:
CHAMPION RG4HC
Electrode gap
0.8 mm
Locking torques (N*m)
Locking torque 12 - 14
- Assemble the casing sealing gasket on the head.
On the fitting direction, use the supplements on the
timing side as reference.
- Assemble the screw fixing the housing to the
crankcase to the specified torque and the 2 self-
threading screws joining the half-shells.
- Take care that the gasket is well inserted in its
housing during the assembly stage.
- Place the spark plug access cap.
Locking torques (N*m)
ENG - 121