Fuel Filters; Fuel Related Components In Cold Weather; Fuel Tanks; Fuel Heaters - Perkins 1204E-E44TA Operation And Maintenance Manual

62 SEBU8605-01
Operation Section
Cold Weather Operation
i02323237
Fuel Related Components in
Cold Weather

Fuel Tanks

Condensation can form in partially filled fuel tanks.
Top off the fuel tanks after you operate the engine.
Fuel tanks should contain some provision for draining
water and sediment from the bottom of the tanks.
Some fuel tanks use supply pipes that allow water
and sediment to settle below the end of the fuel
supply pipe.
Some fuel tanks use supply lines that take fuel
directly from the bottom of the tank. If the engine is
equipped with this system, regular maintenance of
the fuel system filter is important.
Drain the water and sediment from any fuel storage
tank at the following intervals: weekly, service
intervals, and refueling of the fuel tank. This will help
prevent water and/or sediment from being pumped
from the fuel storage tank and into the engine fuel
tank.

Fuel Filters

A primary fuel filter is installed between the fuel
tank and the engine fuel inlet. After you change
the fuel filter, always prime the fuel system in order
to remove air bubbles from the fuel system. Refer
to the Operation and Maintenance Manual in the
Maintenance Section for more information on priming
the fuel system.
The location of a primary fuel filter is important in cold
weather operation. The primary fuel filter and the fuel
supply line are the most common components that
are affected by cold fuel.

Fuel Heaters

Note: The OEM may equip the application with fuel
heaters. If this is the case, the temperature of the fuel
must not exceed 73 °C (163 °F) at the fuel transfer
pump.
For more information about fuel heaters (if equipped),
refer to the OEM information.