Rear Sockets Access - Cisco EX90 User Manual

Cisco TelePresence System EX90
Contents Introduction
Connecting the EX90
Connect the cables as shown. Sockets are located behind the rear cover. If you
have one LAN connection only—and need that for your PC—the EX90 has a built in
Gigabit ethernet switch that enables you to connect your PC to the EX90 to access
the LAN through the EX90.

Rear sockets access

Remove cover to get access to
the connector sockets.
The cover is vented in the
lower left corner (external
view) due to the rear mounted
loudspeaker.
When mounting the cover
back on, make sure the vents
are where the speaker is (as
shown).
Cover vents
The EX90 parts
Camera with built-in privacy shutter.
The Cisco Telepresence
touch screen controller
D14724.06 User guide EX90, TC4.2, July 2011.
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.
Connecting the EX90 Connecting the EX90
Sockets
Connect
headphones
and external
Pull out
microphone here.
Using the EX90 The settings
Connecting
   

Connect your PC here if you need to share a single LAN connection with the
EX90.

Connect your EX90 to the LAN.

USB socket (for future use).

Connect the touch screen controller.

HDMI In (inner socket) and HDMI

Connect power here.
* HDMI out is used when connecting an extra monitor (typically for presentations)—see the next
page for more.
Connecting for use as PC screen
Your EX90 has an HD display, which
also may serve as your PC screen.
Connect your PC to the sockets on the
rear panel as shown below.
Connect your PC video to
A resolution of 1920 × 1200 is recommended. For a list of other
screen resolutions supported, see "Setting the screen resolution"
on page 9.
7
User guide
Web interface Contact us
 
Out* (outer socket).
 
 
and PC audio to
www.cisco.com