Installation Requirements; Tools And Parts - Maytag AUTOMATIC WASHER Use & Care Manual

WARNING:
including the following:
Read all instructions before using the washer.
I
Do not wash articles that have been previously cleaned
I
in, washed in, soaked in, or spotted with gasoline,
dry-cleaning solvents, other flammable, or explosive
substances as they give off vapors that could ignite or
explode.
Do not add gasoline, dry-cleaning solvents, or other
I
flammable, or explosive substances to the wash water.
These substances give off vapors that could ignite or
explode.
Under certain conditions, hydrogen gas may be
I
produced in a hot water system that has not been used
for 2 weeks or more. HYDROGEN GAS IS
EXPLOSIVE. If the hot water system has not been
used for such a period, before using the washing
machine, turn on all hot water faucets and let the water
flow from each for several minutes. This will release
any accumulated hydrogen gas. As the gas is
flammable, do not smoke or use an open flame during
this time.
Gather the required tools and parts before starting installation. The parts supplied are in the
washer basket.
Parts needed (not provided with washer):
Inlet hoses
I
To order:
Call the dealer from whom you purchased your washer.
I
Reference the toll-free number on the front page of the Use and Care Guide.
I
Visit the website on the front page of the Use and Care Guide.
I
NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose
installation or replacement dates for future reference.
4
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basic precautions,
SAVE THESE INSTRUCTIONS

INSTALLATION REQUIREMENTS

N

TOOLS AND PARTS

Flat washers
I
Do not allow children to play on or in the washer. Close
I
supervision of children is necessary when the washer is used
near children.
Before the washer is removed from service or discarded,
I
remove the door or lid.
Do not reach into the washer if the drum, tub or agitator is
I
moving.
Do not install or store the washer where it will be exposed to
I
the weather.
Do not tamper with controls.
I
Do not repair or replace any part of the washer or attempt any
I
servicing unless specifically recommended in this manual or in
published user-repair instructions that you understand and
have the skills to carry out.
See "Electrical Requirements" for grounding instructions.
I
Parts supplied:
A
A. Beaded tie strap
B. Front leveling feet with nuts (2)
C. Drain hose form
N
B
C