Cleaning The Milk Container; Descale - DeLonghi ESAM6620 Instructions For Use Manual

it onto the internal support and pin at the
bottom, then push the PUSH symbol fully in
until it clicks into place.
Please note:
and top as shown in the figure.
7. Once inserted, make sure the
two red buttons have snapped
out.
8. Replace the drip tray and
grounds container.
9. Close the service door.

Cleaning the milk container

Clean the milk container regularly as described
below:
1. Turn the milk container lid clockwise then
remove it.
2. Remove the milk
spout and intake
tube.
3. Remove the
froth regulator
by pulling it
outwards.
4. Wash all the
c o m p o n e n t s
thoroughly with
hot water and
mild washing-up
liquid.
All components
can be washed
in a dishwasher,
placing them in
the top basket of
If the infuser is difficult to
insert, you must first
adapt it to the right
dimensions by pressing it
forcefully from the bottom
the dishwasher.
Make sure there are no milk residues left
inside the holes and the groove on the fine
end of the froth regulator.
5. Check that the intake tube and spout are not
clogged with milk residues.
6. Replace the froth regulator, milk spout and
intake tube.
7. Replace the lid on the milk container, turning
it anticlockwise to hook it in place.

DESCALE

Descale the machine when the message
Important!
Descaler contains acids which may irritate the
skin and eyes.
It is vital to respect the manufacturer's safety
warnings given on the descaler pack and the
warnings relating to the procedure to follow in
the event of contact with the skin and eyes.
Please note:
Use De'Longhi descaler only. Under no
circumstances should you use sulphamic or
acetic based descalers. Their use invalidates the
guarantee. Failure to descale the appliance as
described also invalidates the guarantee.
1. Turn the machine on.
2. Enter the settings menu by pressing the P
button.
3. Press the
symbol flashing on the display) until the
4. Press the
the SET symbol flashing on the display)
activate the function.
displayed.
6. Before confirming, empty the water tank
(A12).
Pour the descaler diluted with water
(respecting the proportions indicated on the
descaler bottle) into the water tank.
Place an empty container with a minimum
capacity of 1.5 litres under the hot water
spout.
18
button (corresponding to the
button (corresponding to
OK to