Turning The Appliance On; Turning The Appliance Off; Changing The Menu Settings; Energy Saving - DeLonghi ESAM6620 Instructions For Use Manual

Please note:
When using the appliance for the first time,
you need to make 4-5 cups of coffee or 4-5
cappuccinos before the appliance starts to give
satisfactory results.

TURNING THE APPLIANCE ON

Please note:
Before turning the appliance on, make sure the
main switch at the back of the appliance is in the
I position (fig. 1).
Each time the appliance is turned on, it performs
an automatic preheat and rinse cycle which
cannot be interrupted.
The appliance is ready for use only after
completion of this cycle.
Danger of burns!
During rinsing, a little hot water flows from the
coffee spouts and is collected in the drip tray.
Avoid contact with splashes of water.
displayed. As well as heating the boiler, the
appliance also heats the internal circuits by
circulating hot water.
The appliance is at temperature when the

TURNING THE APPLIANCE OFF

Each time the appliance is turned off, it performs
an automatic rinse cycle which cannot be
interrupted.
Danger of burns!
During rinsing, a little hot water flows from the
coffee spouts.
Avoid contact with splashes of water.
To turn the appliance off, press the
(fig. 5). The appliance performs the rinse cycle
then goes off.
Please note:
If the appliance is not used for an extended
period, place the main switch on the back of the
appliance in the 0 position (fig. 6).

CHANGING THE MENU SETTINGS

Press the P button to access the programming menu.
The following items can be selected: Clock, Auto-start,
Auto-start time, Descale, Temperature, Auto-off, Water
hardness, Default values, Beep ON/OFF, Energy saving.

Energy Saving

Use this function to enable or disable energy sa-
ving mode.
When enabled, the function reduces energy con-
sumption.
Press the P button.
Press the
Press the
SET symbol flashing on the display) to modify
the function (the appliance displays ENERGY
SAVING YES or ENERGY SAVING NO);
When the function is enabled, if the appliance is
displayed.
Please note:
This is indicated by the display of the messa-
pliance turns the cup warmer on automati-
cally.

Setting the clock

To set the time displayed, proceed as follows:
SET symbol flashing on the display) to set
the time on the clock. (If you hold the button
down, the time changes rapidly).
button
ESC symbol flashing on the display) to exit
programming mode or
parameters.
11
button (corresponding to the
symbol flashing on the display) repeat-
button (corresponding to the
OK button to confirm the function;
P icon to exit the menu.
P button.
button (corresponding to the
OK button to confirm;
P button (corresponding to the
-
to change other