Setting Auto-Start Time; Activating Auto-Start; Descale; Setting The Temperature - DeLonghi ESAM6620 Instructions For Use Manual

Please note:
to display the time with the appliance off, press
any button. The time will be displayed for 5
seconds.

Setting auto-start time

You can set the auto-start time in order to
have the appliance ready at a certain time (for
example in the morning) so you can make coffee
immediately.
been set as described in the previous
section.
P button, then press the
button (corresponding to the
flashing on the display) repeatedly until the
the SET symbol flashing on the display) to
set the auto-start time. (If you hold the SET
button down, the time changes rapidly).
OK button to confirm.

Activating auto-start

SET
the SET symbol flashing on the display) to
modify the function (the appliance displays
AUTO-START YES);
OK button to activate auto-start;
P button (corresponding to the
ESC symbol flashing on the display) to exit
programming mode or
parameters.
Please note:
When the auto-start time is set, the
appears alongside the time on the display.

Descale

For instructions on descaling, see page 18.

Setting the temperature

To modify the temperature (low, medium, high)
of the water used to make the coffee, proceed
as follows:
P button, then press the
button (corresponding to the
flashing on the display) repeatedly until the
symbol
button (corresponding to
button (corresponding to
to change other
symbol
symbol
SET symbol flashing on the display) until
the appliance displays the required coffee
temperature (low, medium,
temperature selected;
P button (corresponding to the
ESC symbol flashing on the display) to exit
programming mode or
parameters.

Auto-Off

The appliance is set to switch automatically to
stand-by if not used for 3 hours.
The time can be changed so that the appliance
switches off after 1, 2 or 3 hours.
P button, then press the
button (corresponding to the
flashing on the display) repeatedly until the
the SET symbol flashing on the display) to
change the number of hours the appliance
remains on.
OK button to confirm.
P button (corresponding to the
ESC symbol flashing on the display) to exit
programming mode or
parameters.

Setting water hardness

For instructions on setting water hardness, see
37.

Default values (reset)

This resets all menu settings and programmed
quantities back to the default values (with the
exception of the language which remains as
set).
P button, then press the
button (corresponding to the
flashing on the display) repeatedly until the
the SET symbol flashing on the display) and
YES
OK button to reset the default
values;
P button (corresponding to the
12
button (corresponding to the
high);
OK button to confirm the
to change other
button (corresponding to
to change other
DEFAULT VALUES NO
button (corresponding to
DEFAULT VALUES
symbol
symbol