Table of Contents
Advertisement
STEP 9:
Position the Camera at a desired angle through PTZ adjustment. Please
refer to the last section for illustration.
STEP 10:
Replace the Dome Cover back.
For Vandal Proof IP Dome Camera,
please align the arrow mark on the
Dome Cover with the one on the
Housing as shown in the top figure.
For Lightweight Fixed Dome IS-DM220,
please align the arc area on the Dome
Cover with the back conduit entry as
shown in the bottom figure.
STEP 11:
Screw on the two Torx Screws on the side of the Dome Cover tightly to
fasten the Dome Cover. Camera installation is complete.
24
Advertisement
Table of Contents
