Table of Contents
Advertisement
1.3
4S Mount Electrical Box
Before installing the IP Dome Camera in the 4S Electrical Box, please unscrew
and open the Dome Cover with the Security Torx.
Follow the steps below to install the 4S Mount Electrical Box:
Figure: 4S Mount Electrical Box
STEP 1:
Run the wires (Ethernet and power) through the wall.
STEP 2:
Disassemble the Dome Camera's Inner Cover (see the illustration in
Ceiling: Step
STEP 3:
Detach the Snap-on Camera Module from the Dome Camera's Housing/
Pleat by unscrewing the Module-fastened Torx Screw first. Then press the
sides of Camera Module and pull it slightly out of the Housing/ Plate.
22
NOTE: The Power Cable is omitted if using PoE.
3) from the Camera Module.
1.1 Hard
Advertisement
Table of Contents
