Table of Contents
Advertisement
Program 10-GP-IP : Intercom or DISA Single Digit Assignment
10-gp-IP S.D.I.
00 00 00 00 00
General:
This program permits the stations in one or more station groups to call a specific station by dialling one digit
only. The settings in this Mode are used by DISA Single Digit Dialling (see Mode 05-11-08 to enable).
Description:
Single Digit Intercom.
When single digit dialling is enabled then the Station to station call pre-fix digit (6) must be dialled to call
another extension.
If a particular group has no entries programmed, the stations in the same number station group will not have
single digit dialling and will not have to use the station to station prefix.
Single Digit DISA.
When single digit dialling is enabled and a group (1-8) selected in Mode 05-11-08 then DISA callers will be able
to dial the stations in the group selected by dialling the digits 1 to 5. The digit 1 will call the first station in the
group, 2 will dial the second station in the group and so on up to digit 5. The caller can also dial 6 and then dial
a full extension number to call other extensions or dial (0 or 9) to call the operator.
If a position is left programmed to 0 then station numbers starting with the digit, which corresponds, to this
position can be dialled in full.
Example
10-gp-IP S.D.I.
11 13 22 00 55
In the above example an incoming DISA caller who dials 1 will call station 11, dialling 2 will call station 13, 3 will
call Station 22. Dialling 4 will allow the caller to dial the full extension number of any extension, which starts with
4, e.g. 44. 55 has been assigned as a Hunt Group Pilot number so a DISA caller dialling 5 will call the Station
hunting group which has 55 as it's pilot Number. Pilot numbers are set in Mode 67 and Hunt groups are
programmed in Mode 68 and 69.
Gp = 01-08, IP = 01-05 (digit 1 to 5)
Station number for digit 1 to 5
G1-824 Programming Manual
99
Advertisement
Table of Contents
