SECTION 1—IMPORTANT SAFEGUARDS
Radio Frequency Interference
This equipment has been tested and found to comply with EMC limits specified by IEC/
EN 60601‐1‐2. These limits are designed to provide a reasonable protection against
electromagnetic interference in a typical medical installation.
Other devices may experience interference from even the low levels of electromagnetic
emissions permitted by the above standards. To determine if the emissions from the XPO
are causing the interference, turn the XPO
stops, then the XPO
2
reduced or corrected by one of the following measures:
• Reposition, relocate, or increase the separation between the equipment.
• Connect the equipment into an outlet on a circuit different from that to which the
other device(s) is connected.
XPO2™
is causing the interference. In such rare cases, interference may be
Off. If the interference with the other device(s)
2
8
2
Part No 1150748