Cebora SOUND MIG 2035/M Pulse Service Manual page 13

CEBORA S.p.A.
♦ Display (G) indicates "dSp" if is the first time you enter in set-up mode, or the
function code present last time you exit the set-up mode.
♦ By pressing the torch start button is possible to select all set-up functions
available for the program selected, indicated by display Q, during operative mode
(see diagram 2.9).
DURING THE FOLLOWING TESTS DO NOT AIM THE TORCH AT PEOPLE OR PARTS
OF THE BODY, BUT ONLY TOWARDS AN OPEN SPACE OR THE WORKPIECE.
Press the torch start button to select the function "Job" in the set-up menu.
Use the button (R) to select the mode continuous, led (L) lit.
Press the buttons (O) or (R) simultaneously to exit the set-up mode.
Press the buttons (O) or (R) to select a work program compatible with the torch being used
and the material available (see tables 2.8) (i.e.: program 1).
Hold down the torch start button for 5 seconds approximately.
♦ Gas begins to flow from the torch, for as long as the button is held down and the
pre-gas and post-gas time selected.
♦ Wire begins to feed from the torch, or at least the wire feeder motors begin
running, for as long as the button is held down.
♦ Open-circuit output voltage is generated for as long as the button is held down.
Move the torch near the workpiece and press the torch trigger.
♦ Begin welding. Turn the knobs (B) and (I) (with traditional torch and manual
programs) to attain the current level and wire speed suited to the welding to be
carried out.
♦ Display (G) indicates the welding current.
Release the torch start button.
♦ Arc shuts off immediately, wire stops feeding from the torch, and gas flow is
interrupted.
3.302.161
Correct?
YES
WARNING
Correct?
YES
Correct?
YES
Correct?
YES
REGULAR OPERATION.
NO (see 3.3.3).
NO (see 3.3.4, 3.3.5)
3.3.6, 3.3.7).
NO (see 3.3.8, 3.3.9).
NO (see 3.3.10).
13
24/03/2004