Quickscan Mobile Cradle Configuration; Quickscan Mobile Reader Configuration - Datalogic QuickScan Mobile Quick Reference Manual

Hide thumbs Also See for QuickScan Mobile:

Table of Contents

DATALOGIC

QUICKSCAN MOBILE CRADLE CONFIGURATION

The QuickScan Mobile cradle configuration can be performed in two ways:

either by sending configuration strings from the Host via the RS-232 or

USB-COM interface or by reading configuration barcodes with the reader.

Serial/USB-COM Configuration

By connecting the QuickScan Mobile cradle to a PC through an RS-232 or USB

cable (only USB-COM interface) it is possible to send configuration strings from

the PC to the reader. Using this method you can also send new configuration

strings from the PC to the reader or upgrade application software onto the

reader.

When the QuickScan Mobile cradle is connected and powered, configure the

QuickScan

Mobile reader by reading the following codes in the given sequence

and follow the instructions.

Note: for the numeric code selection of step 3, use the table at the end of this

Quick Reference Guide.

All readers used in the same area must have different addresses.

Restore QuickScan Mobile default

Ì$+$*oÎ

Enter configuration

Ì$+;Î

Set Radio Address

ÌRF8Î

four digits for the QuickScan Mobile Address

(from 0000 to 1999).

Exit and Save configuration

Ì$-?Î

Table of Contents

Show Quick Links

Table of Contents