Datalogic QuickScan Mobile Quick Reference Manual page 8

USING YOUR QUICKSCAN
Follow the procedure below to start using your QuickScan Mobile reading
system:
1. Connect a QuickScan Mobile cradle to the Host. For installation and
connection information see page 5.
2. Insert the QuickScan Mobile reader into the cradle to start the battery
charging.
A full charge of the Lithium battery takes 3.5 – 6 hours.
To achieve the best battery life, it is recommended to perform a
full battery charge before using the reader in hand-held mode.
NOTE
In hands-free use, you can immediately start using the reader, since it is
powered by the cradle.
3. Configure the QuickScan Mobile reader.
4. Configure the QuickScan Mobile cradle. See QuickScan Mobile cradle
configuration on page 8.
CHANGING THE BATTERIES
To change the battery of your reader, you must:
1. Unscrew the battery cover screw (Figure 1)
2. Unplug the white connector and remove the old battery (Figure 2)
3. Insert the new battery and plug in the white connector
When inserting the new battery into the handle pay attention to
position the battery and the connector just as shown in Figure 3.
NOTE
Figure 1
TM
MOBILE READING SYSTEM
Figure 2
TM
QUICKSCAN
Figure 3
MOBILE
3