System Connections - Datalogic QuickScan Mobile Quick Reference Manual

SYSTEM CONNECTIONS

CAUTION
You can connect the QuickScan
dedicated connector, using the cable corresponding to the desired interface
type.
1. Connect the appropriate interface cable to the cradle by simply plugging it
into the Host connector on the base of the cradle.
To disconnect the cable, insert a paper clip or other similar object into the hole
corresponding to the connector on the base of the cradle. Push down on the clip
while unplugging the cable. Refer to the following figure:
Connections should always be made with power off!
QuickScan Mobile Cradle - Bottom View
Disconnecting the Cable
TM
Mobile cradle to the Host through the
RS-232
USB
TM
QUICKSCAN
Host Interface Cable
MOBILE
5