Configuring Log Settings; Figure 156 View Log; Table 109 View Log - ZyXEL Communications P-660HWP-D1 User Manual

Chapter 20 Logs

Figure 156 View Log

The following table describes the fields in this screen.

Table 109 View Log

LABEL
Display
Email Log Now
Refresh
Clear Log
#
Time
Message
Source
Destination
Notes

20.3 Configuring Log Settings

Use the Log Settings screen to configure to where the P-660HWP-D1 is to send logs; the
schedule for when the P-660HWP-D1 is to send the logs and which logs and/or immediate
alerts the P-660HWP-D1 is to record. See
To change your P-660HWP-D1's log settings, click Maintenance > Logs > Log Settings.
The screen appears as shown.
Alerts are e-mailed as soon as they happen. Logs may be e-mailed as soon as the log is full.
Selecting many alert and/or log categories (especially Access Control) may result in many e-
mails being sent.
264
DESCRIPTION
The categories that you select in the Log Settings screen display in the drop-down
list box.
Select a category of logs to view; select All Logs to view logs from all of the log
categories that you selected in the Log Settings page.
Click Email Log Now to send the log screen to the e-mail address specified in the
Log Settings page (make sure that you have first filled in the E-mail Log Settings
fields in Log Settings).
Click Refresh to renew the log screen.
Click Clear Log to delete all the logs.
This field indicates the log number.
This field displays the time the log was recorded.
This field states the reason for the log.
This field lists the source IP address and the port number of the incoming packet.
This field lists the destination IP address and the port number of the incoming
packet.
This field displays additional information about the log entry.
Section 20.1 on page 263 for more information.
P-660HWP-D1 User's Guide