Double-Check Site Specifics; Unpack And Verify Shipment - sarvaria Multilift Installation Manual

Step 1

Double-check site specifics

Double-check all site specifics and preparatory work by
others prior to installation.
Procedure
1 Prior to delivery, ensure that you have clear access into
the building and a clear route to the installation site.
2 For job site verification, use the following information
sources:
• Plan drawings (also referred to as installation
drawings or shop drawings)
• Written and verbal direction from the customer,
electrical contractors, mechanical contractors,
inspector, and architect.
3 Ensure the installation surface is flat and level, and free
of debris, and will support the lift's load per the plan
drawings. If concrete was poured, ensure the concrete
has set completely.
4 Ensure that the minimum overhead clearance is in
compliance with codes.
5 Verify that all dimensions are per the plan drawings. If
they do not match, contact Savaria's Technical Support
at 1 (800) 791-7999 for assistance.
6 Ensure the electrical installation of a permanent power
source complies with the electrical requirements
provided on the plan drawings.
7 Ensure there are no fire and safety issues. Contact
Savaria's Technical Support at 1 (800) 791-7999 if there
are any fire and safety issues.
8 Verify there is adequate lighting at the landings.
Part No. 000643, 26-m02-2013
Step 2

Unpack and verify shipment

Unpack and verify the contents of the shipment.
Procedure
1 Prior to installation, unpack the shipment and verify the
contents.
2 Check the contents of the shipment against the job
order and the bill of materials. Contact Savaria's
Technical Support at 1 (800) 791-7999 if any parts are
missing or incorrect.
3 Check the condition of the shipment for any damage;
installing damaged parts can lead to safety violations
and void the limited warranty. Contact Savaria's
Technical Support at 1 (800) 791-7999 if any parts are
damaged.
NOTE
If possible, take a photograph of any damaged part(s).
NOTE
On 72" units, be sure to remove the straps that are used to
lock the sling in place during shipping.
Page 5
Multilift Installation Guide