Disassemble/Reassemble The Acme Screw; Disassemble/Reassemble The Acme Screw (If Required) - sarvaria Multilift Installation Manual

Step 17

Disassemble/reassemble the acme screw

(if required)

Disassemble/reassemble the acme screw (if required).

Procedure
WARNING
Always disconnect the power source (power cord and
battery, if equipped) before working on the lift.
Disassemble the acme screw
1 Follow these steps to remove the platform.
a. Remove the underpan.
Figure 31
Remove underpan
b. Remove the car operating panel (COP).
c. Disconnect the travelling cable at the quick connect
plug behind the COP.
Figure 32
Disconnect COP quick connect plug
Part No. 000643, 26-m02-2013
d. Remove the side panel wall on the tower side (four
bolts).
Figure 33
Remove side panel on tower side
e. Remove the four bolts holding the carriage to the
roller supports (two on each side).
Figure 34
Remove bolts holding carriage to roller supports
2 Follow these steps to remove the acme screw:
a. Remove the top cap (two screws).
Figure 35
Remove top cap
Page 19
Multilift Installation Guide