Reverse Automatic Access Ramp (If Required) - sarvaria Multilift Installation Manual

Page 18
Step 16
Reverse automatic access ramp (if
required)
Reverse the automatic access ramp (if required).
Procedure
Follow the steps below to reverse the automatic access
ramp (if required).
1 Remove the top cap and the front panel.
2 Remove the underpan (six bolts).
Figure 26
Remove underpan
3 Remove the automatic access ramp.
Figure 27
Remove automatic access ramp
Multilift Installation Guide
4 Remove the hinge from the platform (five screws).
Figure 28
Remove platform hinge
5 Reverse the position of the actuating arm from one side
of the ramp to the other.
Figure 29
Reverse position of actuating arm on ramp
6 Reinstall the hinge (five screws) and the automatic
access ramp on the other side of the platform (five
screws).
7 Reverse the position of the cam rail from one side of the
tower to the other.
Figure 30
Remove position of cam rail on tower
8 Reinstall the underpan (six bolts).
9 Reinstall the front panel and top cap.
Part No. 000643, 26-m02-2013