sarvaria Multilift Installation Manual page 12

Page 12
NOTE
Refer to Appendix A for drawings illustrating the four
different pro-door installation methods.
Install door with sill channel
1 Center and then anchor the door sill channel to the
landing using the hardware provided (six bolts) as
shown below.
2 Wire the door per the wiring diagrams shipped with the
lift.
Figure 15
Install door with sill channel
Multilift Installation Guide
Anchor door to
landing through
sill channel (6 bolts)
Install door with sill angle
Note that there are two options for installing the door with
sill angle.
• Option 1 – Notch out the landing so the sill angle
bracket is flush with the vertical landing surface. Refer
to Figure 11 on the previous page (note that a gate is
shown in Figure 11 instead of a door but the same
concept applies).
• Option 2 – Install a 1/4" fascia panel to fill in the gap in
the vertical landing surface from underneath the door
sill angle bracket down to the floor/ground. Refer to
Figure 12 on the previous page (note that a gate is
shown instead of a door but the same concept
applies).
1 Center and then anchor the door to the landing using
the hardware provided (four bolts at the front; two bolts
at the back) as shown below.
2 Wire the door per the wiring diagrams shipped with the
lift.
Figure 16
Install door with sill angle
Anchor door to
landing through
sill angle bracket
at front (4 bolts,
two per side)
Anchor door to
landing through
sill angle bracket
at back(2 bolts)
Part No. 000643, 26-m02-2013