sarvaria Multilift Installation Manual page 20

Page 20
b. Remove the front panel (three screws).
Figure 36
Remove front panel
c. Cut the four cable ties holding the travelling cable
to the main crossmember.
Figure 37
Cut cable ties holding travelling cable
d. Remove the bolt holding each roller support to the
main crossmember.
Figure 38
Remove bolts holding roller supports to crossmember
Multilift Installation Guide
e. Remove the two roller supports by sliding them up.
f. Loosen the V-belts by loosening the motor base
(four bolts).
Figure 39
Loosen V-belts by loosening motor base
g. Disconnect the cables going to the switches on the
main nut (load switch and back-up nut switch).
Figure 40
Disconnect cables going to main nut switches
Disconnect
this cable
h. Remove the key inserted in the square nut at the
top of the acme screw.
i. Remove the square nut.
Figure 41
Remove the square nut
Key
Square nut
Part No. 000643, 26-m02-2013