Care And Storage - Partner K650 ACTIVE III Operator's Manual

Pull in
Pull in occurs when the lower part of the blade is suddenly
stopped or when the cut closes. (To avoid this see the section
" How to avoid kickback " and "Pinching/rotation" below)
Pinching/rotation
Pinching occurs when the cut closes. The power cutter can be
pulled down suddenly with a very powerful movement.
How to avoid pinching
Support the work piece in
such a way that the cut
remains open during the
cutting operation and when
the cut is finished.
Abrasive discs
Abrasive discs are not
intended for use with water. If
an abrasive disc is stored in
humid conditions, this can
cause imbalance resulting in
injury.
Check the speed of the
drive shaft
Use a tachometer regularly to
check the speed of the drive
axle at full throttle and without
a load. The maximum speed
is stated on the machine.
!
WARNING!
The machine must be adjusted at an
authorised service workshop before it may be
used, if the speed is higher than that stated on
the machine.
8
– English
SAFETY INSTRUCTIONS

Care and storage

General
Partner's power cutters are robust and durable. However, as
they are used at a high processing rate all service procedures
must be carried out at the times and in the manner described,
so that the machine always works efficiently and safely.
Read this Operator's Manual to determine which service
routines you can carry out and ensure that all other service
work is carried out by an authorised service workshop.
Power cutter
Always handle the power cutter carefully and store it with the
blade removed.
Cutting blades
• All blades should be
removed from the cutter
after use and stored
carefully.
• Special care should be
taken with abrasive discs.
• Abrasive discs must be
stored on a flat, level
surface. If blades are
supplied with a backing
pad then a spacer should
be used to keep them flat.
• Store cutting blades in
dry, frost free conditions.
• Remove the blade before
the power cutter is moved
or transported.
• Inspect new blades for
transport or storage
damage.