GE P385 Use And Care & Installation Manual page 33

Step 7
Install 1/2" Flexible Conduit with Supplied
Clamp
NOTE: A clamp
has been
included with
the cooktop for
Clamp
installing the
1/2" flexible
Stop Tab
conduit.
Clamping
Screw
Remove the screws
holding the wire
compartment cover and
remove the cover.
Remove the clamping
screw and the clamp.
Feed the power
Power Supply
supply leads
through the
conduit; be sure
to leave enough
length to
properly
connect these
leads to the
cooktop power
leads.
Thread the leads through an anti-short bushing
and firmly seat the bushing in the end of the
conduit.
Feed the leads
through the hole in
the wire
compartment.
Lay the conduit
against the side of
the wire
compartment.
Place the clamp
over the
conduit. Make
sure the
Clamp
bushing is fully
seated against
Stop Tab
the stop tab in
the clamp.
Clamping
Tab
Clamping
Tab
Anti-Short Conduit
Leads Bushing
Bushing (Fully Seated)
Tighten the
clamping screw
until the
clamping tab is
fully seated
against the wire
Clamping
compartment. Screw
Complete the rest of the installation observing
local codes (see Steps 9 and 10).
When complete reinstall the wire compartment
cover.
Step 8
Installing the Cooktop
Remove grease jar(s) from beneath cooktop to
avoid breakage. Remove vent grille from
cooktop's surface. Using 2 people, position
cooktop over counter top opening, with power
cable inserted through the opening.
Holding cooktop by side edges, lower it into
countertop opening.
Replace jar(s) and vent grille.
Cooktop
Case
Secure cooktop by tightening hold-down bolts in
bottom of the cooktop case. (2 bolts, 1 per side.)
Clamping
Tab
Countertop
Hold Down Bolt
Clip
(continued next page)
33