Radiant Module - GE P385 Use And Care & Installation Manual

How to Insert the Module
1. Be sure the controls are turned
to OFF. To install the module,
position the plug to the outside
wall of the cooktop.
How to Remove the Module
1. Be sure the controls are turned to OFF and the
radiant surface units are cool before attempting to
remove the module.
2. Lift up the tab at the inside edge of the module
until the base clears the opening at the side of
the cooktop.
General Information About Radiant Modules
The radiant module features heating coils beneath a
smooth glass ceramic surface. The two surface units
are shown by outlines on the glass.
• When a surface unit is activated, coils beneath the
surface unit radiate heat through the glass to the
cookware. The red glow of the coils will be instantly
visible through the glass. It will take the surface unit
a few moments to heat up. The coil cycles on and off
to maintain your selected control setting. The coils
have temperature limiters to prevent runaway
temperatures.
• If you are storing modules, do not stack them or
store other materials on top of them, as damage to
the glass ceramic surface of the radiant module is
likely. Be careful not to damage or bend the
electrical plug.
12

RADIANT MODULE

2. Slide the module toward the
outlet in the side of the cooktop
until the plug is pushed all the
way in.
3. Lower the inside edge of the
module into the cooktop until it
is flush with the cooking
surface.
3. To unplug, hold the module by the front and back
edges and slide toward the center of the cooktop.
Lift out when unplugged.
4. If you are storing modules, do not stack them or
store other materials on top of them. This could
damage the surface of the modules.
• Do not let pots boil dry. Overheated metal can
bond to glass module. An overheated copper pot
will leave a residue that will permanently stain
the module.
• Sliding aluminum cookware across the glass may
leave metal marks. These metal marks will appear
as small scratches. They can be removed with the
recommended cleaning creme and a razor scraper.
• When a surface unit is turned on, the surface unit
can be seen glowing red within a few seconds. The
red glow will turn on and off (cycling) to maintain
the selected heat setting. With poor cookware, you
will see frequent cycling of the unit off and on.
Good, flat cookware will minimize the cycling.
• It is safe to place hot cookware from the oven or
surface on the glass ceramic surface when the
surface is cool.