Chevrolet 1991 Light Duty Truck Repair Manual page 293

SWAGE CLAMP SIZE CHART
TOOL NO. DESCRIPTION
J 36652-1 Split Plate Swage Clamp
J 36652-2 Split Plate Swage Clamp
Split Plate Swage Clamp
J 36652-3
9. Swage Ring
Im portant
m
• Be sure that the retaining ring side of the inner
race (16) faces the axle shaft (12).
Perform steps 1 through 3 in "Outer Joint Seal
Replacement" Install or Connect.
PIVOT CAGE AND INNER RACE AT 90° TO CENTER
LINE OF OUTER RACE WITH CAGE WINDOWS
ALIGNED WITH LANDS OF OUTER RACE.
LIFT OUT CAGE AND INNER RACE.
17
( H ID U j j r H H ------LAND
LAND -----
WINDOWS
17. Cage
18. Outer Race
Figure 48—Separating Outer Race and Cage
8 1/4 AND 9 1/4-INCH RING GEAR 4C4-23
APPLICATION
K 10/20
K 30 (Outboard)
K 30 (Inboard)
J 36652 AXLE
ASSEMBLY
Figure 46— Installing Swage Ring
F6729
MAKE SURE SWAGE RING AND SWAGE
RING CLAMP ARE IN PROPER ALIGNMENT
HOUSING
RING
CLAMP
GENTLY TAP ON CAGE
UNTIL TILTED ENOUGH
TO REMOVE FIRST BALL.
REMOVE OTHER BALLS
IN SIMILAR MANNER.
15. Ball
Inner Race
16.
Cage
17
.
Outer Race
18.
Figure 47—Removing C/V Jo in t Balls
INNER TRI-POT SEAL
REPLACEMENT
|+->| Remove or Disconnect (Figures 40, 46, and 50
through 53)
Tools Required:
J 8059 Snap Ring Pliers
J 35910 Seal Clamp Tool
J 36652 Swage Clamp Tool
SEAL
SWAGE
RING
CLAMP
F6727
HAMMER
BRASS
DRIFT
F6728