Table of Contents
Advertisement
3.
Press A or B until the display shows the user number you wish to use
for the duress code.
The display shows (for example):
4.
Press Enter.
The display shows:
5.
Key in the duress code and press Enter.
The display shows:
6.
Key in the duress code again.
When you key the last digit of the duress code
the display shows:
7.
Press C or D to change from "N" (disabled) to "E" (enabled).
The display shows:
8.
Press Enter.
The system saves the change and the display shows:
9.
Press Menu to finish programming.
If you want to remove a duress code from a user number, follow steps 1 to 8
again but at step 7 press C or D to change the display to "DURSD".
Giving a User Arm Only Access
1.
Start menu 8.
2.
Press Enter until the top line of the display shows "U1-ARMON".
3.
Press A or B until the display shows the correct user number.
The display shows (for example):
4.
Press Enter.
The cursor moves to end of the display:
5.
Press C or D to change between "N" (full use) and "Y" (arm only).
6.
Press Enter.
The system saves the change and the display shows:
Allowing a User to Omit Zones
1.
Start menu 8.
2.
Press Enter until the top line of the display shows "U1-OMITN".
3.
Press A or B until the display shows the correct user number.
The display shows (for example):
496235 Issue 1
5. Supervisor
U7-CNOCO
U7C_
CONF_
U7-DURSN
U7-DURSE
U7-ARMON
U2-ARMON
U2-ARMON
U2-OMITN
U2-OMITN
21
Advertisement
Table of Contents
