Table of Contents
Advertisement
2. Everyday Operation
Keyswitch Setting
1.
Close all doors and windows.
2.
Turn the keyswitch.
3.
Leave the premises and close the final door.
The system sets.
Note that some keyswitches have two setting positions: "Full" and "Part". Ask
your Installer which parts of your premises are covered by each of these
positions.
If the System Will Not Set
If the end station has detected a problem with one or more of the detectors
then the keypad will give a "beep" and show either a fault or a trouble
message.
A fault message means that one of the detectors is being triggered (for
example, a door or window is open). The system will not set until you
have cleared all the faults.
A trouble message means that one of the detectors may be reporting that it
has a technical problem. The system can still set when there is a trouble
message, but you should report the message to you Installer.
For both types of message the keypad display can show you which zones
have problems.
For faults the displays shows (for example):
The system cannot finish setting because two detectors are being
triggered.
1.
Press the A or B keys.
The display shows each zone that is being triggered.
2.
Press A or B repeatedly until you have seen all the faults. Note down
the zones reported.
3.
Go to each zone and find out what is triggering the detector. If possible
remedy the fault.
4.
Go back to the keypad, press Menu, and try to set the system again.
For trouble messages the displays shows
(for example)
The system can still set.
8
496235 Issue 1
SET STOP
02 FLTS
Z IN TRB
1 FLT
Advertisement
Table of Contents
