Table of Contents
Advertisement
5. Supervisor
Changing Access Codes and User Privileges (Menu 8)
You must start from menu 8 for all the facilities described in this section.
To start menu 8:
1.
Key in the User 01 access code.
2.
Press Menu followed by 8.
The display shows:
3.
Press Enter.
The display shows:
Changing User Codes
1.
Start menu 8.
2.
Press Enter until the top line of the display shows "U1-C****".
3.
Press A or B until the display shows the user number whose access
code you wish to change.
The display shows (for example):
4.
Press Enter.
The display shows:
5.
Key in the four digits of the new user code and press Enter. Note that
the display shows "
anyone reading the access code over your shoulder.
The display shows:
6.
Key in the same four digits again.
After you key in the last digit the display
changes to show (for example):
If the display shows:
then you did not key in the confirmation correctly.
Press Menu and go back to step 4.
If the display shows:
then another user already has that access code.
Press Menu and go back to step 4.
Setting Up a Duress Code
The system does not allow a user with a duress code access to any of the
special functions listed in section 4. In addition, the system will not let you
give User 01 a duress code.
1.
Start menu 8.
2.
Press Enter until the top line of the display shows "U1-C****".
20
*
" characters instead of numbers. This is to prevent
496235 Issue 1
8-USER INFO
EDIT USR INFO
U2-C****
U2-C_
CONF_
U2-DURSN
CODE MISMATCH
CODE IN USE
Advertisement
Table of Contents
