Table of Contents
Advertisement
SATA1/SATA2/SATA3/SATA4/SATA5/SATA6: SATA Connector
PIN7
PIN1
SW1: ID LED Button
ID_LED: ID LED
Pin
+
-
State
On
Off
NOTE:
Please visit the TYAN Web Site at
IPMI Configuration Guide for more details.
CLEAR BUTTON 1: Clear CMOS set
Normal
(Default)
Clear CMOS
7
GND
6
SATA RX DP
5
SATA RX DN
4
GND
3
SATA TX DN
2
SATA TX DP
1
GND
Pin
Signal
ID LED BTN
Signal
V3AUX
GND
Color
Blue
Off
The ID LED can be activated remotely using IPMI.
You can reset the CMOS settings by using this button if
you have forgotten your system/setup password or
need to clear system BIOS setting.
-
-
-
NOTE:
steps:
a. Clear CMOS
b. Enter BIOS setup menu and load Default
Settings. Then do a Save and Exit from setup.
http://www.TYAN.com
Connects to the Serial ATA ready drives via
the Serial ATA cable.
SATA0/SATA1:
Support SATA3.0
SATA2/SATA3/SATA4/SATA5:
Support SATA2.0
1
Description
System identified
System not identified
http://www.tyan.com
1.Power off system and disconnect power
connectors from the motherboard
2.Press the button (Clear CMOS)
3.Reconnect power & power on system
After flashing new BIOS please follow the
28
2
ID LED GND
to download the latest
Advertisement
Table of Contents
