Upgrade Firmware - Planet WAP-4050 Manual Manual

No login required
for admin PC
Change Admin
login
New Password
Verify Password
System
Device Name
Firmware version
Config File

2.3.1 Upgrade Firmware

To perform the firmware upgrade, please download the new firmware file to administrative PC first.
After clicking Upgrade Firmware button from System page, you will see the following screen.
If you check this, and provide the MAC address of administrative
PC (see above), you will not be prompted for the password when
using the specified PC.
You should set a password for the admin login, using the password
fields below. This option is provided to allow you to set a password,
but avoid the inconvenience of being prompted for the password
whenever you wish to change the settings.
Check this box to change the current password, and then enter the
required password in the fields below. If this checkbox is enabled,
and the password fields left blank, then the password is cleared (set
to no password).
Enter the new password here.
Note that if the password is set, you will be prompted for the user
name and password when you connect. You must use admin as the
user name.
Re-enter the new password in this field, to ensure it is correct.
The name of the WAP-4050. You can change this if you wish.
This displays the current version of the firmware.
Click the Upgrade Firmware button if you wish to install a new
version of the firmware.
·
You need to download the new firmware file first.
·
Clicking the button will display the Upgrade Firmware screen.
See the following section for further details.
This feature allows you to download (save) the current settings as a
file on your PC, upload (restore) a previously-saved config file. Click
the desired button:
·
Download will prompt you for the location, on your PC, for the
configuration file.
·
Upload will display the Config File screen. See below for
details.
- 14 -