Upgrade Firmware; Save/Load Setting - Planet WNAP-6315 User Manual

5.7.8 Upgrade Firmware

This page allows you upgrade the Access Point firmware to new version. Please note, do not power off the
device during the upload because it may crash the system.
Choose menu "Management  Upgrade Firmware" to upgrade the firmware of the WNAP-6315. Select the
new firmware file downloaded from the PLANET website and then click "Upload" button to upgrade it.
The page includes the following fields:
Object
Firmware Version
Select File
Do not disconnect the Wireless AP from your management PC (the PC you use to
configure the device) or power off it during the upgrade process; otherwise, it may be
permanently damaged. The Wireless AP will restart automatically when the upgrade
process, which takes several minutes, to complete.

5.7.9 Save/Load Setting

Choose menu "Management  Save/Load Setting" to back up or reset the configuration of the WNAP-6315.
Once you have configured the Wireless AP the way you want it, you can save these settings to a configuration
file on your local hard drive that can later be imported to your Wireless AP in case the device is restored to
factory default settings.
Figure 5-64 Upgrade Firmware
Display the current firmware version of the AP.
Browse and select file you want to upgrade and press Upload to perform
upgrade.
Please wait till the related information is shown on the screen after
upgrade is finished.
User Manual of WNAP-6315
Description
-92-