Philips VL440 Spot User Manual page 41

Installing in Truss:
Step 1. Using two people, lift luminaire into mounting position.
Step 2. Secure in place with truss hook. Ensure truss hook hardware that locks hook in place (e.g.
wing bolt) is properly tightened and that luminaire is fully supported.
Step 3. Attach safety cable (as required) as follows (refer to
a. Connect one end of cable to luminaire enclosure handle.
b. Loop at least once around truss/pipe and attach other end of cable to other enclosure
Step 4. Make sure service tilt and pan locks are disengaged so luminaire moves freely.
Step 5. Connect power and data cables according to procedure given in
Power" on page
02.96 87.000 1 0
handle.
Safety Cable:
Recommended for hanging installations.
May be required by local codes. Safety
cable is sold separately.
Figure 2-9: Safety Cable Installation
25.
I : I
NSTALLATION
Enclosure can be oriented in either
direction. See
26 J uly 20 11
P
NSTALLATION ROCEDURES
Figure 2-9):
Figure 2-7
for details.
Enclosure Handles
(see note)
NOTE: The enclosure handles
were tested and are in compliance
(for safety cable anchor points) of
the following safety standards:
- IEC / EN 60598-2-17.6.6
- UL1573
"Connecting Data and
2
23