Philips VL440 Spot User Manual page 105

Step 4. Grasp filter with fingers and gently pull filter assembly straight up and out of fixed color
wheel. Note orientation of fixed color filter. New color filter must go in exactly the same.
Pull filter
straight up
and away
from wheel
assembly
Step 5. At position where fixed color filter was removed, place replacement fixed color filter over
open slot (as shown in
Fixed Color Filter
Mounting Tab
(dimple on front side)
Front of Assembly Shown
(side towards front lens)
Step 6. After filter is installed, reinstall rear head cover.
02.96 87.000 1 0
Fixed Color Filter Assembly
Figure A-5: Removing / Installing Fixed Color Filters
Figure
Figure A-6: Fixed Color Filter Wheel - Filter Installation.
26 J uly 20 11
T
ROUBLESHOOTING AND
Fixed Color Filter Orientation
Light Shield
Mounting Tab
(dimple on front
side)
A-6), slide into wheel, and gently snap filter into place.
M
AINTENANCE
Rear of filter. This side
(reflective side) towards
lamp. Note position of light
shield.
Light Shield
Front of filter. This side
(non-reflective side)
towards front of luminaire.
Note positions of light
shield and dimple in tab.
Light Shield
Open Position
(no filter)
Note:
Assembly shown for clarity.
A
87