Philips VL440 Spot User Manual page 107

Step 4. Grasp gobo carrier with fingers and gently pull gobo assembly straight up and out of rotating
gobo wheel. Note orientation of rotating gobo carrier assembly. New gobo assembly must
go in exactly the same.
Step 5. At position where rotating gobo was removed, place replacement rotating gobo over open
slot (as shown in
Rotating Gobo
Assembly
Front of Assembly Shown
(side towards front lens)
Step 6. After rotating gobo is installed, reinstall rear head cover.
02.96 87.000 1 0
Pull gobo straight up and
away from wheel assembly
Figure A-8: Removing / Installing Rotating Gobos
Figure A-9), slide into wheel, and gently snap gobo into place.
Figure A-9: Rotating Gobo Wheel - Gobo Installation.
26 J uly 20 11
T
ROUBLESHOOTING AND
Rotating Gobo
Rotating Gobo
Carrier Orientation
M
AINTENANCE
Image on this side
Rear of gobo assembly. This
side (reflective side) towards
lamp. Note that gear is on front
of carrier.
Gear Side
(towards front of luminaire)
Open Position
(no gobo)
Note:
Assembly shown for clarity.
A
89