Laser Unit - Brother FAX4759 Service Manual

1.16 Laser Unit

(1) Remove screw "a" and take off the harness cover.
(2) Remove two screws "b."
(3) Disconnect the polygon motor harness and laser flat cable from the laser unit.
(4) Lift up the laser unit.
NOTE: When handling the laser unit, take care not to touch the inside of the unit, glass, or
mirror.
NOTE: On the small PCB in the laser unit is a 2-pin connector which is for the adjustment in
the factory. Do not disturb it.
n n
Reassembling Notes
• Before putting the laser unit back into place, check for any toner particles, paper dust or dirt,
and clean them out.
• After routing the polygon motor harness and laser flat cable, tape them onto the laser unit as
shown above.
"a" and "b": Taptite, cup S M3x16
IV - 29