Appendix A. Power Cables - IBM 220 Service Manual

Appendix A. Power Cables

To avoid electrical shock, a power cable with a grounded attachment plug has been
provided. Use only properly grounded outlets.
Power cables used in the United States and Canada are listed by Underwriter's Laboratories
(UL
consist of:
v Electrical cables, type SVT or SJT.
v Attachment plugs complying with National Electrical Manufacturers Association (NEMA)
v Appliance couplers complying with International Electrotechnical Commission (IEC)
Power cables used in other countries consist of:
v Electrical cables, type HD21.
v Attachment plugs approved by the appropriate testing organization for the specific
Table 4 on page 42 lists the power cable part number, the country where the power cable can
be used, and an index number to be matched with the receptacles shown in Figure 16 on
page 43. If your power cable does not match this information, contact your local dealer.
© Copyright IBM Corp. 2000
™
) and certified by the Canadian Standards Association (CSA
5-15P, that is:
"For 115 V operation use a UL Listed Cable Set consisting of a minimum 18 AWG, Type
SVT or SJT three conductor cable a maximum of 15 feet in length and a parallel blade,
grounding type attachment plug rated at 15 A, 125 V."
"For 230 V operation in the United States use a UL Listed Cable Set consisting of a
minimum 18 AWG, Type SVT or SJT three conductor cable a maximum of 15 feet in
length, and a tandem blade, grounding type attachment plug rated at 15 A, 250 V."
Standard 320, Sheet C13.
countries where they are used.
"For units set at 230 V (outside of U. S.): Use a Cable Set consisting of a minimum 18
AWG cable and grounding type attachment plug rated 15 A, 250 V. The Cable Set should
have the appropriate safety approvals for the country in which the equipment is to be
installed and marked 'HAR'."
™
). The power cables
41