Appendix C. Safety Inspection Procedures - IBM 220 Service Manual

Model 220 4mm tape drive
Table of Contents

Advertisement

|

Appendix C. Safety Inspection Procedures

© Copyright IBM Corp. 2000
Use the following procedures to identify unsafe conditions. Be cautious of potential
safety hazards not covered by the procedures. If unsafe conditions are present,
determine how serious the hazards are and whether you should continue before
correcting the problem.
Figure 17 shows the components to review during the service inspection.
Figure 17. Safety Inspection
Perform the following safety checks.
1. Do a controlled system shutdown (refer to the instructions in Chapter 2,
"Setting Up the 7206 Tape Drive," in the 7206 Model 220 4mm Tape Drive Setup
and Operator Guide).
2. Turn off the power to all external devices connected to the system unit.
3. Turn off the power to the 7206 Tape Drive ( 1 in Figure 17).
4. Turn off the power to the system unit 2 .
47

Advertisement

Table of Contents
loading

This manual is also suitable for:

7206

Table of Contents