Removing And Replacing The Drive - IBM 220 Service Manual

Removing and Replacing the Drive

To remove the drive from the 7206 Tape Drive:
1. Perform the cover removal procedure. Refer to "Removing and Replacing the
2. Disconnect the power supply connector (J1) ( 1 in Figure 11) from the drive.
3. Disconnect the SCSI bus cable 2 from the drive.
4. Disconnect the SCSI address cable 3 from the drive.
5. Tilt the 7206 Tape Drive on its side (see Figure 11). Support the drive 4 while
6. Support the drive while returning the 7206 Tape Drive to its original position.
7. Slide the drive out the front of the chassis.
Figure 11. Removing and Replacing the Drive
30
7206 Model 220 Service Guide
Cover" on page 28.
removing the four screws 5 that secure the drive to the chassis.