Operating Your Transmitter - Regency ANDROS Owner's Manual

O Y
PERATING OUR
Restore power to ceiling fan and test for proper operation.
Install 9 Volt battery (included). To prevent damage to transmitter remove the
batteries if not used for long periods of time. (Fig. 1)
1. "LO, MED, HI" buttons:
These three buttons are used to set the fan speed as follows:
LO= Low speed MED= Medium speed
HI= High speed
2. "OFF" button:
This button turns the fan off.
3. The " " button are controlled by pressing the light button. Tap button
quickly to turn light off or on. Push the button once and release to turn the
light on to full brightness. Hold the button down to increase or decrease
light brightness. Release the button at the desired light brightness and that
setting will be remembered the next time the light is turned on. The pre-set
brightness can be changed by holding down the light button again until the
new desired brightness is reached.
NOTE: If power is lost to the fan receiver, the memory will be lost and all NOTE:
settings will return to the default.
Range of the transmitter is approximately 25 ft. A new alkaline battery will
typically give range of 35 ft. or more.
T
RANSMITTER
11
Fig. 1
Fig. 2