Operating Your Transmitter - Regency Artiste Owner's Manual

O Y
PERATING OUR
Your DC brushless motor is equipped with a automatically learned type
remote control.(If two fans or more in a house, it is recommended that you
not use the factory code settings. Change codes setting to any other combina-
tion of dip switch setting to avoid fan interference issues, but users need to do
control setting process as below once the code setting is changed. Please refer
the "E" "SET" code setting button section.) Restore power to ceiling fan and
test the transmitter as below for proper operation:
Install one 23A/12V battery (included). To prevent damage to transmitter,
remove the battery if not used for long periods of time (Fig. 1)
A. I, II, III, IV, V and VI button:
These six buttons are used to set the fan speed as follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
B. button:
This button turns the fan off.
C. Reverse button:
This button is to control fan direction
D. Light button
This button is to control light. Switch the "D" and "ON" dip switch on the
back of transmitter to decide the light in "ON/OFF" or "Dimmable" condition.
E. SET code setting button:
Follow the below steps to set the remote control:
The auto learning function will only mandate within 60 seconds when turning
the fan's AC power ON.
a) Select desired frequency from the back of transmitter.
b)
With the fan' s power off, restore power to the fan.
ter,
Press and hold "SET" button for about 5 seconds and release. If the light kit is
installed, the light kit will flash twice and the signal light on the remote control will come
on when the button is pressed. The fan has completed the pairing process with the remote
control and is ready for use.
NOTE: If the self calibration test failed, turn the AC power off; restore power
and process the self calibration test again.
NOTE: During self calibration test, the remote is non-fuctional.
NOTE: The learning frequency function and self calibration test will continue
to retain the last set frequency and calibration set even when the AC power is
shut off. If the frequency is changed the self calibration test will occur again.
F. "D" and "ON" dip switch:
The "ON" selection is the light dimmable selection and is to be used with all
bulbs except for CFL bulbs. The "D" selection is the light ON only (no dim-
ming function) and is to be used with CFL bulbs as CFL bulbs in most cases
cannot be used with dimming controllers.
T
RANSMITTER
From the back of the transmit-
9
ON ECE
ON ECE
1 2 3 4
Fig. 1
Fig. 2