Controls And Indicators - Air Techniques ScanX Duo Instruction Manual

conTRol and IndIcaToRs
Scanner Track 2
Indicator LED
POWER
Switch
Figure 2 . ScanX Duo Front Panel Controls and Indicators
Keypad Control Panel
POWER Switch
Ready/Standby
Green LED indicator
ERASER Switch
FLASHING OFF
Blue LED indicator
Scanner Tracks 1 & 2
Indicator LEDs
Page 10
FLASHING OFF
Blue LED Indicator
Ready/Standby
Green LED indicator
Keypad Control Panel
Toggles between the Standby and Ready mode as follows:
1 . Press to switch from the Standby mode to the Ready mode .
2 . Press and hold down for at least 2 seconds to switch to the Standby mode
from the Ready mode .
Illuminates green
When extinguished, it indicates that ScanX is in the Standby mode .
Toggles between turning the Erase function OFF and ON . This switch has no effect
once the plate scanning or erasing starts .
Illuminates steady blue to indicate that the Erase function is ON and PSPs will be
erased after scanning .
Flashes blue to indicate that the Erase function is OFF and PSPs will not be erased
after scanning .
Illuminate green when the Scanner has been activated, indicating that a PSP can
be fed into ScanX track .
Illuminate yellow, indicating the PSP has been sensed and the Scanner is transporting
the PSP in the associated track .
USB
Connector
Type B
Main Power
Switch (1/0)
2A Circuit
Breakers
IEC
Connector
Figure 3 . ScanX Duo Rear Panel Controls and Connectors
Scanner Track 1
Indicator LED
ERASER
Switch
to indicate that ScanX
Item
USB Connector Type B
Main Power Switch (1/0)
2A Circuit Breakers
IEC Connector
is Ready for operation .
Function
Provides USB connection from the
computer via the supplied USB
Computer Connector Cable
Controls the application of ScanX
operating power .
Protects against shorts in the internal
electrical circuits .
Provides connection of Mains out-
let power via supplied line cord .
Air Techniques, Inc.