Controls And Indicators - Air Techniques ScanX B7300 Instruction Manual

COMPUTER SYSTEM REQUIREMENTS
System Properties.
If unsure of the operating system version installed,
check that it meets the necessary requirements by
checking the S S y y s s t t e e m m P P r r o o p p e e r r t t i i e e s s window.
This is done simply by right clicking the M M y y C C o o m m p p u u t t e e r r
i i c c o o n n . . Selecting P P r r o o p p e e r r t t i i e e s s from the menu list displays the
S S y y s s t t e e m m P P r r o o p p e e r r t t i i e e s s window as shown. The installed oper-
ating system version is listed under the G G e e n n e e r r a a l l T T a a b b . .
The S S y y s s t t e e m m P P r r o o p p e e r r t t i i e e s s window can also be displayed
from the Desktop S S t t a a r r t t button. Just press the S S t t a a r r t t button
and select S S e e t t t t i i n n g g s s C C o o n n t t r r o o l l P P a a n n e e l l and then S S y y s s t t e e m m . .
Ready/Standby
Green LED
indicator
READY READY
READY
Switch
Keypad Control Panel
K K e e y y p p a a d d C C o o n n t t r r o o l l P P a a n n e e l l
READY Switch
Ready/Standby
Green LED indicator
ERASER Switch
FLASHING OFF
Blue LED indicator
4 4 S S c c a a n n n n e e r r T T r r a a c c k k I I n n d d i i c c a a t t o o r r L L E E D D s s

CONTROLS AND INDICATORS

FLASHING OFF
ERASER
Blue LED
Switch
Indicator
FLASHING FLASHING
ERASER ERASER
ALLPRO ALLPRO
IMAGING IMAGING
Toggles between the Standby and Ready mode as follows:
1. Press to switch from the Standby mode to the Ready mode.
2. Press and hold down for at least 2 seconds to switch to the
Standby mode from the Ready mode.
Illuminates green to indicate that the ScanX is Ready for operation.
When extinguished, it indicates that the ScanX is in the Standby mode.
Toggles between turning the Erase function OFF and ON. This switch
has n n o o effect once the plate scanning or erasing starts.
Illuminates steady blue to indicate that the Erase function is ON and
PSPs will be erased after scanning.
Flashes blue to indicate that the Erase function is OFF and PSPs will
n n o o t t be erased after scanning.
Illuminate green when the Scanner has been activated, indicating
that a PSP can be fed into the ScanX.
Illuminate yellow, indicating the PSP has been sensed and the
Scanner is transporting the PSP .
OFF OFF
Scanner Track
Indicator LEDs
11