Repeat Playback; Ntsc Playback - JVC HR-S7700EK Instructions Manual

Repeat Playback

Your video recorder can automatically play back the whole tape
100 times repeatedly.
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
The Play indicator ( ) on the display panel blinks
slowly.
The tape plays 100 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.

NTSC Playback

Your video recorder is equipped with NTSC circuitry that can
play back NTSC tapes.
LOAD A CASSETTE
1
Insert a cassette recorded in NTSC.
START PLAYBACK
2
Press PLAY.
"NTSC PAL" appears on the screen for about 5
seconds.
Some TVs shrink the picture vertically and place
black bars at the top and bottom of the screen. This is
not a malfunction on the part of either the video
recorder or the TV.
The picture may roll up and down. This can be
corrected using the V-HOLD control found on some
TVs. (This cannot be corrected if the TV does not
have a V-HOLD control.)
The counter and tape remaining time readings will be
incorrect.
During search, still, or frame-by-frame playback, the
picture will be distorted, and there may be a loss of
colour.
Depending on the type of TV, the top and bottom
portions of superimposed displays may be cut off
during NTSC playback.
Retake
You can cut out unnecessary parts of a TV programme while
you're recording it.
End of programme
Unnecessary
Programme
part
Recorded part
Go back to end of programme to cut out
unnecessary part
ENGAGE RECORD-PAUSE
MODE
1
Press PAUSE during recording.
LOCATE START POINT
2
Turn the JOG dial to the left or right (or hold down
REW or FF) and release it when you reach the point
where you want to resume recording.
* Your recorder returns to the Record-Pause mode.
RESUME RECORDING
3
Press PLAY when you wish to resume recording.
NOTE:
Retake function does not work during Direct Rec (
43
Beginning of programme
Unnecessary
Programme
part
pg. 11).