Video Plus+ Timer Programming - JVC HR-S7700EK Instructions Manual

18
VIDEO Plus+
Timer
Programming
Before performing the VIDEO Plus+ Timer Programming:
Make sure that the recorder's built-in clock is set
properly.
Insert a cassette with the safety tab in place. The recorder
will come on automatically.
Turn on the TV and select the VIDEO channel (or AV mode).
1
2
4
NUMBER
5
7
PDC
STOP+/–
1
1,6
PROG
– –:– –
3
2
2
5 6
8 9
7
4
0
4
?
SP/LP
3,6
OK
BASIC OPERATIONS (cont.)
With the VIDEO Plus+ system, timer programming is greatly
simplified because each TV programme has a corresponding
code number which your recorder is able to recognise.
ACCESS VIDEO PLUS+ SCREEN
1
Press PROG.
The front display panel looks like this:
ENTER PLUSCODE NUMBER
2
Press the NUMBER keys to
enter the PlusCode
number of the programme
you wish to record.
If you make a mistake,
press and input the
correct number.
The PlusCode number you enter appears on the front
display panel:
The display panel shows only a 4-digit number.
ACCESS VIDEO PLUS+ PROGRAM
SCREEN
3
Press OK, and the VIDEO
Plus+ Program screen
appears (if you're just
starting out, "P1" appears).
The display panel shows the
programme start time.
Pressing changes the
display to the programme
stop time, then the date and
preset position.
IMPORTANT
Make sure the preset position number you wish to
record is displayed; if not, see "VIDEO Plus+ Setup"
on page 45 and set the Guide Program number for
that PlusCode number correctly.
If the number you entered is invalid, "ERROR" appears
on the screen and "Err" appears on the display panel.
Press and input a valid PlusCode number.
If the "GUIDE PROG SET" screen appears, see
"ATTENTION – Regarding Guide Program Number
Set" on page 19.
V I D EO P LU S +
[0 – 9] = VIDEO PLUS+
[+/–] : EXPRESS PROGRAMING
[PROG] : EXIT
V I D EO P LU S +
1 2 3 4 5 6 7 8
[0 – 9] =
[ ] : DELETE
[PROG] : EXIT
– P1 –
VIDEO PLUS+ 123456789
START STOP
=
21:00 22:00
SP VPS/PDC OFF
DATE TV PROG
25.12 1
BBC 1
: OK
SP